This is default featured slide 3 title
This is default featured slide 4 title
This is default featured slide 5 title
 

Level A Floor Before Tiling

Before starting your floor levelling project, it is important that you have the proper tools, materials and techniques available. Ensure you have the following before starting this project:

  • Floor leveling compound
  • A Four-foot level Nylon String
  • A Trowel
  • A Drill and Mixing bucket
  • A Five-gallon bucket

Step 1

Identify the high and low spots by using a level. Mark out any low spots using a pencil by drawing wide circles around them.

Step 2

Mix up some floor leveler in the bucket (according to the levelling compound instructions). Usually this involves a bucket being filled with two inches of water. You then pour in enough levelling compound to cover it. You then mix the compound with the water until you have a consistent texture. The levelling compound instruction will tell you the water to powder ratio. Remember that your climate can change how well your levelling compound mixes. You may have to make adjustments.

Step 3

Keep adding levelling compound and water until you have a full gallon mixture. The mixture should have the consistency of the thin soup.

Step 4

Pour your mixed levelling compound batch over low spots that you marked earlier. Always work your way out from the corner, furthest from the door. Give it time to settle and level out before pouring more. Use your trowel to flatten any spots in which the leveler does not flatten itself.

Step 5

Fill in the remaining low spots whilst backing out the room as you go. Let it set for at least 24 hours. You are then ready for your next step, which is tiling the floor.

Tiling Your Perfectly Flat Floor

Floor levelling compounds are fast curing. This means you need to work quickly before it dries. Some can even be walked on within 3 hours. However, it is recommended you leave you new floor for at least 24 hours to be sure the coating has cured sufficiently.